It is possible that the Gateway Eero is working correctly, but the connection through one Eero device on the network is affected. Sadly, there is no desktop app at the moment. If you plan on moving into a new place, are selling your Eero system, or are just having issues with it, here's how to factory reset it so you can start fresh from square one. Your mileage may vary, though. Tap on "Delete Network" again when the pop-up appears. Source: https://www.howtogeek.com/288226/how-to-factory-reset-the-eero-home-wi-fi-system/, Posted by: vaillancourtthioseen.blogspot.com. Currently, when im not holding the reset button the light blinks white for a long time and then turns into a solid red. Be sure to keep the units plugged in until the Eero system is completely reset, at which point the LED light on each unit will begin blinking blue when the reset has complete. It is possible that the Gateway Eero is working correctly, but the connection through one Eero device on the network is affected. Set up requirements: Ethernet cable To begin, open up the Eero app and tip on the menu button in the top side-left corner of the screen. Well explain the steps to do this in the next section. Make sure you're following these instructions to properly do hard reset (in case you haven't been doing it right): https://support.eero.com/hc/en-us/articles/215473703-How-do-I-reset-my-eero- If that doesn't help, go ahead and reach out to eero support so they can further assist you. The eero Beacon reset button can be found on the left side and the same instructions below apply. RELATED: How to Set Up the Eero Home Wi-Fi System. It's only available on iOS and Android currently, and it's required to set everything up. You successfully conected with WPS with eero Eero. How to Set Up the Eero Home Wi-Fi System - How-To Geek You can use either of the Ethernet ports on the back of your eero. This saves you the time and inconvenience of fixing each device individually. How do i get my eero out of pairing mode? : r/eero If you experience any trouble connecting specific devices to your new eero network, try disconnecting and reconnecting WiFi on the device. Right away, though, you should notice a huge difference in yourWi-Fi signal and speed once you switch to your Eero network. Once youve set up your gateway eero, your new network has been created and you can begin adding additional eeros to extend your network. Cost trusted to hold up the units plugged in until the Eero system is completely reset, at which point the LED light on to each one unit leave begin blinking blue when the reset has full-scale.
how to set up eero after hard reset